QC Location Configuration

There are different ways to handle Quality Control.

It's possible to have a fixed location where all products go through as a separate operation within the BOL.

However it's also possible to have floating QC where a user wanders and does spot inspections with a tablet.


In any case, the location where QC is done needs to be configured to allow handling of QC.

In the Manage-Locations menu this is configured by checking the QC flag under each location that should be enabled to perform audits.



The QC magnifying glass will be visible for all users working on an operation with QC enabled.

This is to allow for repairs as they are done and seen from the same view within the Tablet.

It can also be seen as an incentive to perform well as a possible inspection is known.


However only users with a tablet where QC is enabled in the location are allowed to actually use the audit function to perform QC.


Copyright © 2020 by Exenta. All rights reserved.

Created with the Personal Edition of HelpNDoc: Easily create Help documents